Natupol is Koppert’s flagship product. This standard product is perfect for a wide range of crops, grown on surfaces bigger than 2000 m2 and with approximately 25-35 flowers per m2 per week (for example round and plum tomatoes).
How does Natupol work?
After their release, worker bumblebees start pollinating the crop. They are supported by more workers born in the weeks after their introduction.
The improved visibility of the hives among the crop (Beevision) is based on the way bumblebees see. Bumblebees now easily find the hive, fewer bumblebees get lost in the greenhouse and pollination improves.
How to use Natupol
Distribute the Natupol hives evenly along the main path of the greenhouse
Place the colonies on a horizontal platform (avoid inclination, otherwise sugar water may leak)
During summer; Position the hive about 20-60 cm above the ground on the south-side of a path to obtain maximum shade from the crop. If needed, provide additional shading.
During winter; Position the hive near the top of plants on the north side of the main path. Ensure that the hive is exposed to the first daylight.
Wait at least for 15 minutes after positioning the hives before opening the hive entrance, this allows the bumblebee colonies to calm down.
Best working conditions Natupol
Natupol performs best at ambient temperatures of between 10-30°C
Every hive contains food in order to keep the bumblebees in good condition during transport and storage.
To guarantee the best pollination results, start using the hive on the day of arrival.
Start using the hive no later than one day after arrival.
Maintain the bumblebees at a temperature of between 15 – 25°C.
Avoid direct sunlight on the hive.
Use and Hygiene
Never move a hive from one greenhouse to another
Prevent bumblebees from leaving the greenhouse
Remove bumblebee hive 6-8 weeks after introduction
Clean the hive stand before placing new hives
Seal old hives into plastic bags and dispose them according to local legislation.
Special points of attention
Make sure the hives and the entrances are well visible, so the bumblebees easily find their way home.
Place no more than two hives next to or close to each other. To reduce drift of bumblebees, make sure each hive entrance points into a different direction.
Please note that direct sunlight on the hive can increase the internal hive temperature with 5-15°C. It is important to provide shade in warm conditions.
Make sure ants cannot reach the sugar water of the hive by making a barrier of grease or insect glue. Also avoid contact between plants and the hive, so that ants cannot reach the hive.
Avoid colonies to be placed in the direct surrounding of the CO2 supply, or in other locations where CO2 can reach high levels (over 2500 ppm).